Table of Contents
Advertisement
10/100/1000Base-T (Port 9)
The 10/100/1000Base-T port comes with Auto-Negotiation capability, which
automatically supports 1000Base-T, 100Base-TX and 10Base-T networks. Users
only need to plug a working network device into the 10/100/1000Base-T port, and
then turn on the FGSD-910P. The port will automatically run in 10Mbps, 20Mbps,
100Mbps or 200Mbps and 1000Mbps or 2000Mbps after negotiating with the
connected device.
Cabling
Each 10/100Base-TX and 10/100/1000Base-T port uses RJ-45 sockets -- similar
to phone jacks -- for connection of unshielded twisted-pair cable (UTP). The IEEE
802.3 / 802.3u / 802.3ab Fast / Gigabit Ethernet standard requires Category 5 UTP
for 100Mbps 100Base-TX. 10Base-T networks can use Cat.3, 4, 5 or 1000Base-T
use 5/5e/6 UTP (see table below). Maximum distance is 100 meters (328 feet).
Port Type
10Base-T
100Base-TX
1000Base-T
Any Ethernet devices like hubs/PCs can connect to the FGSD-910P by using
straight-through wires. The nine RJ-45 ports are auto-MDI/MDI-X, which can be
used on straight-through or crossover cable.
2.3 Desktop Installation
To install the PoE Ethernet Switch on desktop, simply follow the following steps:
Step 1: Attach the rubber feet to the recessed areas on the bottom of the PoE
Ethernet Switch, as shown in Figure 2-3.
FG SD -9
10 P
Figure 2-3: Place the FGSD-910P on the Desktop
Cable Type
Cat 3, 4, 5, 2-pair
Cat.5 UTP, 2-pair
Cat.5/5e/6 UTP, 4-pair
8 -P o rt 1
0 /1 0 0 M
b p s+ 1
G ig a b it
8 0 2 .3 a
f
P o E S w
it ch
10/ 100
LN K
AC T
1
1
2
PW R
2
Spe ed
3
4
3
5
6
4
7
8
9
PoE
LNK /
AC T
5
6
7
8
9
Gig abi t
Connector
RJ-45
RJ-45
RJ-45
11
Advertisement
Table of Contents
