Installing The Poe Injector Hub; Desktop Installation - Planet HPOE-1200G User Manual

2.2 Installing the PoE Injector Hub

This section describes how to install your PoE Injector Hub and make connections to the PoE Injector Hub. Please read the
following topics and perform the procedures in the order being presented. PLANET PoE Injector Hub does not need
software configuration.

2.2.1 Desktop Installation

To install a PoE Injector Hub on a desktop or shelf, simply complete the following steps:
Step 1: Attach the rubber feet to the recessed areas on the bottom of the PoE Injector Hub.
Step 2: Place the PoE Injector Hub on a desktop or shelf near an AC power source.
Step 3: Keep enough ventilation space between the PoE Injector Hub and the surrounding objects.
When choosing a location, please keep in mind the environmental restrictions discussed in Chapter
1, Section 5, under Specifications.
Step 4: Connect your PoE Injector Hub to network 802.3at / 802.3af powered devices (PD) and Switch.
A. Connect one end of a standard network cable to the upper stack 10/100/1000 RJ45 ports on the front of the PoE
Injector Hub.
B. Connect the other end of the cable to the 802.3at / 802.3af powered devices (PD) such as IP phone, wireless
access point, IP camera, splitter, or switch etc.
C. Connect one end of a standard network cable to the relative lower stack 10/100/1000 RJ45 port on the front of
the PoE Injector Hub.
D. Connect the other end of the cable to the port of Switch.
Connecting to the PoE Injector Hub requires UTP Category 5e / 6 network cabling with RJ45 tips.
For more information, please see the Cabling Specification in Appendix A.
Step 5: Supply Power to the PoE Injector Hub.
A. Connect one end of the power cable to the PoE Injector Hub.
Connect the power plug of the power cable to a standard wall outlet.
B.
When the PoE Injector Hub receives power, the Power LED should remain solid Green.
User's Manual of POE-1200G / POE-2400G / HPOE-1200G / HPOE-2400G
17