Hardware Installation; Desktop Installation - Planet GSD-808HP User Manual

8-port 1/100/1000mbps 802.3at poe+ desktop switch

Hide thumbs Also See for GSD-808HP:

Table of Contents

5. Hardware Installation

This section describes the functionalities of the Gigabit Ethernet Switch's

components and guides how to install it on the desktop and rack mount. Basic

knowledge of networking is assumed. Please read this chapter completely before

continuing.

This following picture shows the user how to install the device, but

the device is not the GSD-808HP.

Note

To install the Switch on the desktop, simply follow the steps below:

Step1: Attach the rubber feet to the recessed areas on the bottom of the Switch,

as shown in Figure 5-1.

Figure 5-1: Attaching the Rubber Feet to the Switch

Step 2: Place the Switch on the desktop near an AC power source.

Step 3: Keep enough ventilation space between the Switch and the surrounding

objects.

Step 4: Connect your Switch to 802.3af/at complied powered devices and other

network devices.

A. Connect one end of a standard network cable to the 10/100/1000 RJ45

ports on the front panel of the Switch.

B. Connect the other end of the cable to the network devices such as

printer servers, workstations and router.

Table of Contents