Table of Contents
Advertisement
Per 10/100/1000Mbps Port
LED
Color
Speed
Green
LNK/ACT
Green
2.2 Rear Panel
The rear panel of the FGSD-910P indicates an AC inlet power socket, which accepts
input power from 100 to 240V AC, 50-60Hz, 2A.
The device is a power-required device, meaning it will not work till
it is powered. If your networks should be active all the time, please
consider using UPS (Uninterrupted Power Supply) for your device.
It will prevent you from network data loss or network downtime. In
some area, installing a surge suppression device may also help to
Power
protect your FGSD-910P from being damaged by unregulated
Notice
surge or current to the FGSD-910P or the power adapter.
Before start up
Before your installation begins, please refer to the following for your cabling:
10/100Base-TX (Port 1 to Port 8)
All 10/100Base-TX ports come with Auto-Negotiation capability. They automatically
support 100Base-TX and 10Base-T networks. Users only need to plug a working
network device into one of the 10/100Base-TX ports, and then turn on the FGSD-
910P. The port will automatically run in 10Mbps, 20Mbps, 100Mbps or 200Mbps
after negotiating with the connected device.
10
Light: Indicate the link through that port is successfully
established at 1000Mbps.
Blink Slowly: Indicate the link through that port is
successfully established at 100Mbps.
Off: Indicate the link through that port is successfully
established at 10Mbps.
Light: Indicate the link through that port is successfully
established
Blink: Indicate that the Switch is actively sending or
receiving data over that port.
Figure 2-2: FGSD-910P Switch Rear Panel
Function
100~240V AC
50/60Hz, 2A max.
Advertisement
Table of Contents
