Set Friendly; Set Ip; Set Location; Set Telnet Port - AMX MCP-106 Instruction Manual

SET FRIENDLY

SET IP

SET LOCATION

SET TELNET PORT

SET TELNET USERNAME

SET TELNET PASSWORD

SHOW CONNECTION LOG

Terminal Commands (Cont.)
Command
Instruction Manual - Massio ControlPads and Keypads
Set the device's friendly name for NDP to <name>.
Syntax:
SET FRIENDLY <name>
• Maximum length = 25 characters. If the name entered exceeds 25 characters, it will be truncated.
• The value is stored in non-volatile memory.
• If no value specified, an automatic name consisting of AMX, the product name, and serial number
will be used.
NOTE: This command requires a reboot to enable new settings.
Sets the IP configuration of a specified device.
Enter a host name, type (DHCP or Fixed), IP address, subnet mask, and gateway IP address.
NOTE: "DHCP" implies "DHCP with link-local fallback".
NOTE: For NetLinx Masters, the "Host Name" can only consist of alphanumeric characters.
• Enter Y (yes) to approve/store the information into the Master.
• Enter N (no) to cancel the operation.
NOTE: This command requires a reboot to enable new settings.
Example:
>SET IP
--- Enter New Values or just hit Enter
to keep current settings ---
Enter Host Name: MLK_INSTRUCTOR
Enter IP type. Type D for DHCP or S for Static IP and
then Enter: DHCP
Enter Gateway IP: 192.168.21.2
You have entered: Host Name
Type
Gateway IP
Is this correct? Type Y or N and Enter -> y
Settings written. Device must be rebooted to enable
new settings.
NOTE: Metreau keypads can also be set to Static IP or DHCP Mode by using the ID Pushbutton.
See the Toggling Between IP Addressing Modes: DHCP and Static IP section on page 27 for
details.
Sets the location parameter for NDP.
Syntax:
SET LOCATION <location>
• Maximum length = 25 characters. If the name entered exceeds 25 characters, it will be truncated.
NOTE: This command requires a reboot to enable new settings.
Sets the device's IP port listened to for Telnet connections.
Example:
>SET TELNET PORT
Current telnet port number = 23
Enter new telnet port number (Usually 23)(0=disable Telnet):
Once you enter a value and press <Enter>, you get the following message:
Setting telnet port number to 23
New telnet port number set, reboot the device for the change to take effect.
NOTE: This command requires a reboot to enable new settings.
See the Enabling/Disabling Telnet on the Keypad section on page 43 for additional information.
Set the user name for a secure Telnet session.
• Default = blank (no user name required)
• See the Setting a Telnet User Name and Password section on page 38 for details.
Set the Password for a secure Telnet session.
• Default = blank (no password required)
• See the Setting a Telnet User Name and Password section on page 38 for details.
Show the master connection log for the device.
Description
MLK_INSTRUCTOR
DHCP
192.168.21.2
Programming
42