AMX MCP-106 Instruction Manual page 20

FIG. 19 illustrates how to connect the device frame to the mounting bracket.
Attaching the frame to the mounting bracket (MCP-106 displayed)
FIG. 19
6. Press the sides of the device frame to snap them into place.
7. Press the bottom corners of the device frame to snap them into place. The metal clip on the mounting bracket should align
with the open spaces located at the bottom of the device frame. The clip should fit inside this space and lock the device frame
into position on the mounting bracket. There are two metal clips on the 8-button Massio devices. There is only one on the
6-button devices.
FIG. 20 displays the location of the metal clip on the 6-button devices.
Metal clip from mounting bracket locking device frame onto bracket
FIG. 20
FIG. 21 displays the locations of the metal clips on the 8-button devices.
Metal clips from mounting bracket locking device frame onto bracket
FIG. 21
8. Connect the faceplate to the device frame by snapping the top corners of the faceplate into place on the device frame. If
connected properly, the faceplate should hold itself in place against the device frame.
NOTE: If you need to label the buttons on the device or replace any key caps, it is best to do so before attaching the faceplate. Consult
the Button Labeling section on page 21 for instructions.
9. Press the bottom corners of the faceplate until each corner snaps into place with the device frame.
Instruction Manual - Massio ControlPads and Keypads
Metal clip from mounting bracket
Metal clips from mounting bracket
Hook top of frame onto the lip
of the mounting bracket
Installation
20