Renew Dhcp; Reset Factory; Set Connection; Set Device - AMX MCP-106 Instruction Manual

RENEW DHCP

RESET FACTORY

SET CONNECTION

SET DEVICE

SET DNS

SET ETHERNET MODE

Terminal Commands (Cont.)
Command
Instruction Manual - Massio ControlPads and Keypads
Renews/Releases the current DHCP lease for the keypad.
Example:
>RENEW DHCP
Resets the device's stored parameters to factory default state including removal of all security set-
tings, resetting to DHCP.
This command will cause an automatic reboot.
NOTE: This command does not reset the device to the factory software image.
Set the master connection settings interactively, allowing the user to specify the mode.
• If mode is TCP or UDP, the master URL and port number can be specified as well.
• If AUTO is selected, the System number can be specified.
• After all data is entered, if the parameters have changed, the Module will disconnect from the
Master, and begin trying to connect with the new settings.
NOTE: These changes do not require a reboot to take effect.
Set the device number, and store in non-volatile memory.
Syntax:
SET DEVICE <num>
The valid range of device numbers is 0-31999.
• If the user enters a number outside that range, then no change will be made and the Module will
issue an error message.
• A Device Number of '0' means that the Module will accept the auto-assigned device number from
the Master.
• If the new device number is different from the old device number, the Module will disconnect from
the Master, and begin trying to connect with the new settings.
NOTE: These changes do not require a reboot to take effect.
Set the DNS configuration of the EXB Module, only as applied to Static IP addressing mode (DNS
settings in DHCP mode are received from the DHCP server).
Syntax:
SET DNS <D:P:S>
This command prompts you to enter a Domain Name, DNS IP #1, DNS IP #2, and DNS IP #3.
• Enter Y (yes) to approve/store the information in the Master.
• Enter N (no) cancels the operation.
NOTE: The device must be rebooted to enable new settings.
Example:
>SET DNS [0:1:0]
-- Enter New Values or just hit Enter to keep current settings --
Enter Domain Suffix: amx.com
Enter DNS Entry 1 : 192.168.20.5
Enter DNS Entry 2 : 12.18.110.8
Enter DNS Entry 3 : 12.18.110.7
You have entered: Domain Name: amx.com
DNS Entry 1: 192.168.20.5
DNS Entry 2: 12.18.110.8
DNS Entry 3: 12.18.110.7
Is this correct? Type Y or N and Enter -> Y
Settings written. Device must be rebooted to enable new settings
This command sets the current LAN configuration settings per new mode.
Syntax:
SET ETHERNET MODE <newmode>
Values for newmode are:
auto
- or -
10 | 100 full | half
NOTE: This command requires a reboot to enable new settings.
Examples :
set ethernet mode auto
set ethernet mode 100 full
NOTE: See the GET ETHERNET MODE command on page 40.
Description
Programming
41