Default User Names And Passwords; Massio Keypads; Locating The Ip Address Of The Keypad; Toggling Between Ip Addressing Modes: Dhcp And Static Ip - AMX MCP-106 Instruction Manual

Default User Names and Passwords

The following table lists the default user names and passwords for accessing the Massio ControlPads through NetLinx Studio or the
WebConsole.
Default User Names and Passwords
NetLinx Studio
WebConsole
For more information about navigating and the features of the WebConsole, see the NX-Series WebConsole and Programming
Guide available at www.amx.com.

Massio Keypads

The following sections provide instructions on accessing and configuring the keypad.

Locating the IP Address of the Keypad

The MKP-106 is configured for DHCP addressing by default. The keypad uses link local addressing as a backup in case the DHCP
server is inaccessible. See the Toggling Between IP Addressing Modes: DHCP and Static IP section for information on setting a static
IP address. Verify there is an active LAN connection on the controller's LAN port before beginning this procedure.
1. Using category cable, connect the LAN port on the keypad to your external network.
2. In NetLinx Studio, select the OnLine Tree tab. You should see the Keypad listed among the Unbound Devices.
3. Right-click the Keypad and select Network Bind/Unbind Device from the menu that appears. The Bind/Unbind Device dialog
opens.
4. By default, the selected keypad appears in the Device to Bind/Unbind menu at the top of the dialog. If there is more than one
Unbound device in the system, click the down arrow to select which device you want to bind.
5. Select the check box next to the Master to which you want to bind the keypad. If there is more than one Master in the system,
check the specific Master to which you want to bind the keypad.
6. Click OK to save changes and close this dialog.
7. Select Refresh System (in the Online Tree context menu). The device should now appear in the Bound Devices folder.

Toggling Between IP Addressing Modes: DHCP and Static IP

Massio Keypads support both DHCP and static IP addresses. You can use a static IP address which you can set via a Telnet
command (SET IP), or you can use the factory default static IP address (192.168.1.2).
With the keypad powered and booted up (or in ID Mode), you can toggle between the DHCP and Static IP modes by pressing and
holding buttons 1 and 2. The LEDs on buttons 1 and 2 blink while you keep them pressed. Hold them until the LEDs begin blinking
at double the rate (approximately10 seconds), then release the buttons.
When you release the buttons, the keypad toggles either from static to dynamic (DHCP) IP addressing or vice versa and remains in
that mode until the you use the buttons to toggle the IP mode again or you perform a factory reset. The keypad automatically
reboots to complete the process.
NOTE: You must wait until the keypad is f inished booting before toggling the IP address. Pressing the buttons while booting will cause
the keypad to restore its factory default settings.
Instruction Manual - Massio ControlPads and Keypads
User Name Password
netlinx password
administrator password
Initial Configuration
28