Changing The Controlpad's Network Address Information - AMX MCP-106 Instruction Manual

3. Click Search For Masters to search the network for online Masters in the Search for Masters dialog (FIG. 29).
Search for Masters dialog
FIG. 29
4. Click Start Searching to begin listening for "blink" (UDP) messages from NetLinx Masters on the subnet.
5. When you see the IP Address for the ControlPad in the List of Active NetLinx Master Controllers, click Stop Listening. The IP
address of the ControlPad is listed in the TCP/IP column of the dialog.

Changing the ControlPad's Network Address Information

1. Select Options > Master's Network Address to open the Master Controller's Network Address dialog (FIG. 30):
Master Controller's Network Address dialog
FIG. 30
2. Edit the IP Address fields as necessary:
• Host Name:
• Use DHCP/
Specify IP Address:
• IP Address:
• Subnet Mask:
• Gateway:
• Set IP Information:
3. Click the Set IP Information button to set the new IP address information on the ControlPad. The program will prompt you
that the Master Controller will be rebooted when this button is pressed (click OK to proceed).
Instruction Manual - Massio ControlPads and Keypads
Use this field to view/edit the ControlPad's current Host Name.
Use these radio buttons to specify whether to use DHCP, or to Specify an IP Address for the
ControlPad. DHCP is selected by default.
NOTE: If you select DHCP, the IP Address and Subnet Mask f ields (below) are disabled for
editing.
Use this field to view/edit the ControlPad's current IP Address.
Use this field to view/edit the ControlPad's current Subnet Mask assignment. Click the help icon
to open the Valid Subnet Masks help topic, which lists valid subnet masks, and the maximum
number of IP hosts allowed for each.
Use this field to view/edit the ControlPad's current Gateway assignment.
Sets the new IP information, as indicated in this dialog.
NOTE: RPMLoader will reboot the ControlPad when the Set IP Information button is clicked.
Initial Configuration
25