Button Labeling; Overview; Installing Acetate Button Labels - AMX MCP-106 Instruction Manual

Button Labeling

Overview

Massio ControlPads and Keypads come with a set of clear plastic Button Caps which are designed to fit tightly over the
pushbuttons, and allow you to place a label on each button according to the requirements of your particular installation.
Massio devices also come with a pre-printed acetate sheet with a range of 70 (pre-cut) button label inserts. The button labels
provided will accommodate most installations, but it is also possible to print your own button labels on acetate for custom button
labeling.
Acetate sheet of 70 standard button labels (pre-cut)
FIG. 22

Installing Acetate Button Labels

Follow these instructions to install the acetate button labels and Button Caps:
1. Remove the faceplate from the device.
2. Remove the cone and diffuser from the button. The cone and diffuser are adhered together and should not be separated.
3. Peel off the desired Button Label from the included acetate sheet. If you have printed your own custom button labels on
acetate, cut each button label to fit inside the Button Caps.
Custom button labels must be cut to a 14mm (0.55") square to fit securely inside the Button Caps.

The thickness of the acetate used must not exceed .004" (0.10 mm).

4. Place the Button Cap face-down, and insert the Button Label into the bottom of the Button Cap (FIG. 23).
Orient the Button Label inside the Button Cap so that the two clips are located on the top and bottom sides of the readable

text on the Button Label, as indicated in FIG. 23.
Be sure to place the Button Label face-down inside the Button Cap, otherwise the label will be seen in reverse.

Instruction Manual - Massio ControlPads and Keypads
Button Labeling
21