Horizon Fitness ANDES 3 Owner's Manual page 7

ASSEMBLY step 6
ANDES 3
ANDES 5
LOWER HANDLEBAR
LOWER HANDLEBAR COVERS
PRE-ATTACHED FLAT WASHER (B)
PRE-ATTACHED LINKAGE AXLE (C)
LINKAGE TUBE
LINKAGE ARM
12
A Remove the PRE-ASSEMBLED SCREWS (E) from
the end of the lower handlebar.
B Remove the PRE-ASSEMBLED NUT (A),
WASHERS (B), LINKAGE AXLE (C) and BOLT (D)
from the linkage piece.
C Put the LINKAGE AXLE (C) into the linkage tube,
and then attach the linkage arm inside the lower
handlebar linkage piece using 2 PRE-ASSEMBLED
WASHERS (B), 1 BOLT (D), and 1 NUT (A).
d Attach the handlebar covers onto the lower handlebar
PRE-ATTACHED SCREW (E)
using PRE-ASSEMBLED SCREWS (E).
E Repeat steps A-D on the opposite of the elliptical.
PRE-ATTACHED NUT (A)
PRE-ATTACHED BOLT (D)
LINKAGE PIECE
ASSEMBLY step 7
CONSOLE
PRE-ATTACHED SCREW
(ANDES 3)
(ANDES 5)
A Remove the 4 PRE-ASSEMBLED SCREWS.
B Attach the 3 CONSOLE CABLES to the console
C Carefully tuck the CONSOLE CABLES into the
CONSOLE MAST before attaching the CONSOLE.
d Attach CONSOLE to the CONSOLE MAST using the
4 PRE-ASSEMBLED SCREWS.
Note : Be careful not to pinch any wires while attaching
the console.
ANDES 3
ANDES 5
13