Download
Share
Print this page
Horizon Fitness Andes 3 Service Manual
  1. Manuals
  2. Brands
  3. Horizon Fitness Manuals
  4. Fitness Equipment
  5. Andes 3
  6. Service manual

Horizon Fitness Andes 3 Service Manual

Hide thumbs Also See for Andes 3:

Advertisement

Quick Links

Download this manual See also: Owner's Manual, Operating Manual
Andes 3 Service manual

Advertisement

loading

Related Manuals for Horizon Fitness Andes 3

Summary of Contents for Horizon Fitness Andes 3

  • Page 1 Andes 3 Service manual...
  • Page 2 TABLE OF CONTENTS CHAPTER I SERIAL NUMBER LOCATION CHAPTER II CONSOLE INSTRUCTION CHAPTER III ELECTRON DIAGRAMS CHAPTER IV TROUBLESHOOTING...
  • Page 3 CHAPTER I SERIAL NUMBER LOCATION 1-1 Serial Number Location...

  • Page 4: Quick Start

    CHAPTER II CONSOLE INSTRUCTION CONTROLS Click 3 seconds hold 5 seconds hold Increase Next item Decrease Previous item Quick start Finish inputting user ’s name Select item Start the workout Enter to the next step Stop the workout Reset Language selection Back to the previous step Metric /British selection QUICK START...

  • Page 5: Monitoring Your Heart Rate

    MONITORING YOUR HEART RATE Feedback Your Horizon Fitness elliptical trainer offers two heart rate feedback options. You may choose to use the heart rate handlebars, or the chest transmitter (sold separately) for a hands free workout. Heart Rate Handlebar Place the palm of your hands directly on the heart rate handlebars.
  • Page 6 Center the chest strap just below the breast or pectoral muscles, directly over your sternums, with the Horizon Fitness logo facing out. NOTE: The chest strap must be tight and properly placed to receive an accurate and consistent readout. If the chest strap is too loose, or positioned improperly, you may receive an erratic or inconsistent heart rate readout.
  • Page 7 CHAPTER III ELECTRON DIAGRAMS Refer the attached file (AutoCAD format)
  • Page 8 CHAPTER IV TROUBLESHOOTING No RPM display Symptom: No RPM shown on the console. Reason: 1. Bad connection between the console cable and the console 2. Speed sensor wire defective 3. Loss magnet of pulley 4. Console defective Solution: 1. Re-connect the console wire. 2.
  • Page 9 CHAPTER IV TROUBLESHOOTING No resistance or Incorrect resistance Symptom： ： ： ： 1. The resistance is un-adjustable during exercise. 2. The resistance is reverse or much too heavier. Reason： ： ： ： 1. Speed sensor wire is defective. 2. Console cable or ECB motor is defective. 3.
  • Page 10 CHAPTER IV TROUBLESHOOTING If output is DC 6V, the MCB motor defective. Replace ECB motor. B) If the ECB motor can move, the resistance can be adjusted. If the resistance is still much too heavier. Check the gap between orange block and the bottom. It shall be within 1-2 If the gap is bigger than 1-2 mm, the resistance will be heavier than normal.
  • Page 11 CHAPTER IV TROUBLESHOOTING No power to the console Symptom: Console does not light up. Reason: 1. Adaptor not correct or defective. 2. Console cable defective. 3. Console defective. Solution: 1. The adaptor for this model is 12V -1A. Ensure to use the correct specification of an adaptor, and replace the adaptor if it is defective.