Horizon Fitness ANDES 3 Owner's Manual page 6

ASSEMBLY step 4
ANDES 3
ANDES 5
NUT(K)
PIVOT-TUBE
SPRING WASHER(J)
TEFLON WASHER(I)
PEDAL ARM
10
HarDWare parts:
TEFLON WASHER (I) SPRING WASHER (J)
Φ12.2XΦ25X1.5T Φ12.2XΦ21.5X3.0T
Qty: 4 Qty: 2
A Open HARDWARE FOR STEP 4.
B Remove PRE-ASSEMBLED SCREWS from the front
PRE-ATTACHED SCREW
end of the PEDAL ARM.
C Place the PEDAL ARM SET onto the PIVOT-
TUBE using 2 TEFLON WASHERS (I), 1 SPRING
WASHER (J) and 1 NUT (K).
Note: The black surface of teflon washers touch the
pedal arm end plate.
TEFLON WASHER(I)
d Attach the PEDAL ARM COVER onto the PEDAL
ARM using 1 PRE-ASSEMBLED SCREW.
PRE-ATTACHED SCREW
E Attach the ROLLER WHEEL COVER onto the
ROLLER WHEEL COVER
PEDAL ARM using 1 PRE-ASSEMBLED SCREW.
F Repeat B-E steps on the other side.
ASSEMBLY step 5
NUT (K)
M12X1.25PX10
Qty: 2
CONSOLE MAST
WAVY WASHER(L)
FLAT WASHER(M)
CONSOLE CABLE
LOWER HANDLEBAR
HarDWare parts:
WAVY WASHER (L)
Φ26xΦ34x0.3t
Qty: 2
A Open HARDWARE FOR STEP 5.
UPPER HANDLEBAR
B Remove the PRE-ASSEMBLED BOLT & WASHERS
from CONSOLE MAST.
HANDLEBAR COVERS
C Attach UPPER HANDELBAR onto CONSOLE
SCREW(N)
MAST using 1 FLAT WASHER (M), 1WAVY
WASHER (L), 1 PRE-ATTACHED FLAT WASEHR, 1
PRE-ATTACHED SPRING WASHER and 1 PRE-
PRE-ATTACHED
ATTACHED BOLT.
FLAT WASHER
PRE-ATTACHED
d Attach the CONSOLE CABLE (Andes 5 only).
SPRING WASHER
E Remove the PRE-ASSEMBLED SCREWS from
HANDLEBARS.
PRE-ATTACHED BOLT
F Attach LOWER HANDLEBARS to UPPER
HANDLEBARS using PRE-ASSEMBLED SCREWS.
PRE-ATTACHED SCREW
Attach HANDLEBAR COVERS using 2 SCREWS (N).
g
H Repeat step B-g on the other side.
ANDES 3
FLAT WASHER (M) SCREW (N)
ANDES 5
Φ25.5xΦ35x1.0t Φ4x15L
Qty: 2 Qty: 4
11