Conversion To Another Gas; Levelling; Fitting The Handles And Handrail (Classic Only) - Rangemaster Classic 110 Dual Fuel User's Manual & Installation Instructions

Check the appliance is electrically safe and gas sound when you have finished.
Fig.7.10
ArtNo.215-0026 - Handle gaskets fixed
Fig.7.11
ArtNo.210-0006 - Classic fitting the handles 2
Fig.7.12
Art No 215-0028 - Handrail fascia fixings
INSTALLATION

Conversion to Another Gas

If the appliance is to be converted to another gas do the
conversion at this point. See the conversion section of these
instructions.

Levelling

You are recommended to use a spirit level on a shelf in one of
the ovens to check for level.
Place the cooker in its intended position taking care not to
twist it within the gap between the kitchen units as damage
may occur to the cooker or the units.
The front feet and rear rollers can be adjusted to level the
cooker.
To adjust the height of the rear of the cooker use a 13 mm
spanner or socket wrench to turn the adjusting nuts at the
front bottom corners of the cooker.
To set the front, turn the feet bases to raise or lower.
Fitting the Handles and Handrail
only)
Remove the 4 mm Allen screws from the doors (Fig.7.10). Fit
the door handles and secure using the 4 mm screws.
The handles should be above the fixings.
n n
Fit the plastic blanking plugs to the fixing holes (Fig.7.11).
Remove the 4 mm Allen screws from the top corners of the
fascia (Fig.7.12). Fit the handrail in position and secure using
the 4 mm screws.
22
(Classic