Aligning Manually And Cutting - Roland SOLJET PROIII XC-540 User Manual

3-3 Cutting Using the Crop-mark Feature
If the crop marks cannot be detected easily because of the effects of media warping or the like, then
perform alignment manually.
When you want to perform automatic alignment with lengthy media, we recommend performing output
with the data separated into sizes that are as short as possible. With large sizes, error due to warping
and the like increases, making smooth detection impossible.
To Quit Detection and Start Cutting

CANCEL CROPMARK

Press
This stops detection and starts cutting.
Note: After pressing
P. 90, "Pausing or Canceling Output"


Aligning Manually and Cutting

Depending on the type of media, it may not be possible to detect crop marks automatically. When crop
marks cannot be detected automatically, you perform alignment manually.
1.
Set the base point.


56
Chapter 3 Using the Cutting Feature
Press
DETECTION?
Crop-mark detection stops. Depending on the con-
tent of the data, some time may pass before detec-
tion actually stops.
.

in step
Press
.
resuming detection or canceling output is also possible.
Use
of the blade with the location
shown in the figure.
.
to align the center