Replacing The Side Panel And Connecting The Cables; Updating The Computer Configuration; Configuring Plug And Play Adapters - IBM Aptiva E 2270 User Manual

Also, depending on the option installed, you might need to update information in
the Configuration/Setup Utility program.
The following list is a quick reference to these procedures:
• "Replacing the side panel and connecting the cables" on page 28
• "Updating the computer configuration" on page 28

Replacing the side panel and connecting the cables

To replace the side panel and connect cables to your computer:
1. Ensure that all components have been reassembled correctly and that no
tools or loose screws are left inside your computer.
2. Clear any cables that might impede the replacement of the side panel.
3. Position the side panel with the handle at the rear.
4. Ensure that the top and bottom cover retainers align with the top and bottom
slots on the chassis.
5. Slide the side panel forward so the retainer clips engage the chassis.
6. Insert the two phillips head screws into the holes at the top and bottom of the
side panel and the chassis and tighten.
7. Reconnect the external cables and cords to the computer. See "Cable
connections and switch settings" on page 6.

Updating the computer configuration

You might need to install device drivers after updating the configuration settings.
For more information, see the instructions that come with the option to determine
if device drivers are required and how to install them.
Note: For more information about error messages from resource conflicts, see
Chapter 5 "Technical Troubleshooting" on page 31.

Configuring Plug and Play adapters

Along with the documentation that comes with your adapter, use the following
information to help with adapter configuration.
Plug and Play is a configuration method that makes expanding your computer
easier. The system board of your computer supports operating systems that use
Plug and Play technology.
28 IBM PC User Guide