Table of Contents
Advertisement
10. Replace the cover and connect the power cord. See "Replacing the cover and
Replacing the cover and connecting the cables
After working with options, you need to install any removed parts, replace the
cover, and reconnect any cables, including telephone lines and power cords. Also,
depending on the option that is installed, you might need to confirm the updated
information in the Setup Utility program.
To replace the cover and connect cables to your computer:
1. Ensure that all components have been reassembled correctly and that no tools
2. Clear any cables that might impede the replacement of the cover.
3. Position the cover on the chassis so that the rail guides on the bottom of the
4. Install any cover locking devices such as a cable lock or padlock as necessary.
5. Reconnect the external cables and power cords to the computer. See "Installing
6. To update the configuration, see Chapter 2, "Using the Setup Utility program,"
5. Move the jumper from the standard position (pins 1 and 2) to the
maintenance or configure position (pins 2 and 3).
6. Replace the cover and connect the power cord. See "Replacing the cover and
connecting the cables."
7. Restart the computer, leave it on for approximately ten seconds. Turn off the
computer by holding the power switch for approximately five seconds. The
computer will turn off.
8. Repeat steps 2 through 4 on page 24.
9. Move the jumper back to the standard (pins 1 and 2).
connecting the cables."
or loose screws are left inside your computer.
cover engage the rails and push the cover closed until it latches.
external options" on page 6.
on page 27.
Chapter 1. Installing options
25
Hide quick links:
Advertisement
Table of Contents
