Replacing The Cover And Connecting The Cables - IBM ThinkCentre 8143 User Manual

10. Replace the cover and connect the power cord. See "Replacing the cover and

Replacing the cover and connecting the cables

After working with options, you need to install any removed parts, replace the
cover, and reconnect any cables, including telephone lines and power cords. Also,
depending on the option that is installed, you might need to confirm the updated
information in the IBM Setup Utility program.
To replace the cover and connect cables to your computer:
1. Ensure that all components have been reassembled correctly and that no tools
2. Clear any cables that might impede the replacement of the cover.
3. Position the cover on the chassis so that the rail guides on the bottom of the
4. Install any cover locking devices such as a cable lock or padlock as necessary.
5. Reconnect the external cables and power cords to the computer. See "Installing
6. To update the configuration, see Chapter 2, "Using the IBM Setup Utility
7. Restart the computer, leave it on for approximately 10 seconds. Turn off the
computer by holding the power switch for approximately 5 seconds. The
computer will turn off.
8. Repeat steps 2 through 4 on page 24.
9. Move the jumper back to the standard (pins 1 and 2).
connecting the cables."
or loose screws are left inside your computer.
cover engage the rails and push the cover closed until it latches.
external options" on page 6.
program," on page 27.
Chapter 1. Installing options
25