Table of Contents
Advertisement
10. Use the IBM Setup Utility program to set the date and time and any
Replacing the cover and connecting the cables
After working with options, you need to install any removed parts, replace the
cover, and reconnect any cables, including telephone lines and power cords. Also,
depending on the option that is installed, you might need to confirm the updated
information in the IBM Setup Utility program.
To replace the cover and connect cables to your computer:
1. Ensure that all components have been reassembled correctly and that no tools
2. Clear any cables that might impede the replacement of the cover.
2. Unplug the power cord and remove the cover. See "Removing the cover" on
page 10.
3. Locate the battery. See "Identifying parts on the system board" on page 11.
4. If necessary, remove any adapters that impede access to the battery. See
"Installing adapters" on page 14 for more information.
5. Remove the old battery.
6. Install the new battery.
7. Replace any adapters that were removed to gain access to the battery. See
"Installing adapters" on page 14 for instructions for replacing adapters.
8. Replace the cover, and plug in the power cord. See "Replacing the cover and
connecting the cables".
Note: When the computer is turned on for the first time after battery
replacement, an error message might be displayed. This is normal after
replacing the battery.
9. Turn on the computer and all attached devices.
passwords.
or loose screws are left inside your computer.
Chapter 1. Installing options
21
Advertisement
Table of Contents
