Specify Dhcp Server Settings - TP-Link Archer C2600 User Manual

Done!
Tips
11. 3

Specify DHCP Server Settings

By default, the DHCP (Dynamic Host Configuration Protocol) Server is enabled and the router acts as a DHCP server; it
dynamically assigns TCP/IP parameters to client devices from the IP Address Pool. You can change the settings of DHCP Server
if necessary, and you can reserve LAN IP address for specified client device.
1. Visit http://tplinkwifi.net, and log in with the username and password you set for the router.
2. Go to Advanced > Network
Chapter 11 . Customize your network settings
2 ) Click Save.
3 ) After configuring IGMP proxy, IPTV can work behind your router now. You can connect your
set-top box to any of the router's LAN port.
If IGMP is not the technology your ISP apply to provide IPTV service:
1 ) Select the Enable IPTV
2 ) Select the appropriate
no other parameters are required, and then skip to Step 4. Select
listed but provides necessary parameters.
3 ) After you have selected a mode, the necessary parameters are predetermined. You can
perform other configuration, e.g. enter the
Multicast VLAN Priority
4 ) For Russia, Singapore-ExStream, Malaysia-Unifi and Malaysia-Maxis mode, connect device to the
predetermined LAN port. For Bridge and Custom mode, select the
box to the corresponding port.
Save
5 ) Click .
Your IPTV setup is done now! You may need other configurations on your set-top box before
enjoying your TV.
Qos and IPTV cannot be enabled at the same time.
> DHCP Server.
check box.
Mode according to your ISP. Select
IPTV Multicast VLAN ID
in Russia mode according to your ISP.
Bridge if your ISP is not listed and
Custom if your ISP is not
and select the
LAN
type and connect the set-top
IPTV
52