TP-Link Archer C2600 User Manual page 80

Ac2600 wireless dual band gigabit router

Hide thumbs Also See for Archer C2600:

Table of Contents

Q5. I cannot access the Internet even though the configuration is finished, what can I do?

1. Visit http://tplinkwifi.net, and log in with the username and password you set for the router.

2. Go to

Advanced

As the follow picture shows, if IP Address is a valid IP address, please try the methods below and try again:

Your computer might not recognize any DNS server addresses, please manually configure DNS server.

1 ) Go to

Advanced

2 ) Enter 8.8.8.8 as Primary DNS, click Save.

Tips:

8.8.8.8 is a safe and public DNS server operated by Google.

Power cycle the modem and the TP-LINK router.

1 ) Power off your modem and TP-LINK router, leave them off for 1 minute;

2 ) Power on your modem first, wait about 2 minutes until it get a solid cable or Internet light;

3 ) Power back TP-LINK router;

4 ) Wait another 1 or 2 minutes and check the Internet access.

Reset the router to factory default settings and reconfigure.

Note:

You'll have to reconfigure the router to access the Internet once the router is reset.

1 ) Reset the router to factory default settings: press and hold the RESET button for at least 10 seconds and then release;

FAQ

Status

to check Internet status:

Network

DHCP

Server;

Table of Contents

Show Quick Links

Table of Contents