5. Remove the three screws
Figure 165. Removing the three screws
6. Pivot the drive partition in the direction as shown. Then remove it from the rear of the drive bays.
Figure 166. Removing the drive partition
7. Store the drive partition in case that you later remove the optical drive cage and install 2.5-inch drives
and dummy trays (if any).
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the removal procedure, go to "Completing the parts replacement" on page 193.
Installing the optical drive
Attention: Do not open your server or attempt any repair before reading and understanding "Safety information"
on page iii and "Guidelines" on page 67.
1
.
1
1
.
Chapter 6
Replacing hardware
171