Lenovo ThinkServer RD650 User Manual And Hardware Maintenance Manual page 164

7. Position the drive adapter and the drive into the 3.5-inch drive bracket. Align the screw holes in the drive
adapter and the drive with the corresponding holes in the bracket. Then, install the screws to secure
the drive adapter and the drive into the bracket.
Figure 136. Installing the screws to secure the drive adapter and the drive to the bracket
8. Slide the bracket with the drive into the drive bay from the front until it snaps into position and then
completely close the handle.
Figure 137. Installing the bracket with the drive
9. Check the drive status LEDs to ensure that the drive is operating correctly. You might have to restart the
server for the newly installed drive to be recognized. See "Hot-swap-drive activity and status LEDs" on
page 51. If the drive is faulty, reinstall or replace it until it is operating correctly.
10. Save the removed dummy tray in case that you later remove the drive and need a dummy tray to
cover the drive bay.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To configure RAID, go to "Configuring RAID" on page 62.
• To complete the installation, go to "Completing the parts replacement" on page 193.
150
ThinkServer RD650 User Guide and Hardware Maintenance Manual