Lenovo ThinkServer RD650 User Manual And Hardware Maintenance Manual page 188

10. Slide the new optical drive into the optical drive bay from the front until it snaps into position.
Figure 171. Installing the optical drive
11. Do the following to connect the optical drive to your server:
a. Connect the connector
Figure 172. Connecting the connector
b. Connect the 2-pin power connector on the other end of the cable to the 2-pin power connector on
the backplane. See "Backplane for up to eight 2.5-inch drives" on page 42.
c. Connect the SATA connector on the other end of the cable to the appropriate SATA connector on the
system board. See "System board components" on page 44.
12. Save the removed optical drive dummy in case that you later remove the drive and need the dummy
to cover the drive bay.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the removal procedure, go to "Completing the parts replacement" on page 193.
174
ThinkServer RD650 User Guide and Hardware Maintenance Manual
1
on one end of the cable to the rear of the optical drive.
1
1
on one end of the cable to the rear of the optical drive