Installing Or Removing The M.2 Storage Module - Lenovo ThinkServer RD650 User Manual And Hardware Maintenance Manual

To remove the TPM, do the following:
1. Remove all external media from the drives and turn off all attached devices and the server. Then,
disconnect all power cords from electrical outlets and disconnect all cables that are connected to
the server.
2. Prepare your server. See "Removing or extending the server from the rack cabinet" on page 69.
3. Remove the server cover. See "Removing the server cover" on page 69.
4. Remove the riser card assembly 2. See "Replacing the riser card" on page 85.
5. Locate the TPM connector on the system board and then lift the installed TPM straight up.
Note: Carefully handle the TPM by its edges.
Figure 94. Removing the TPM
6. If you are instructed to return the old TPM, follow all packaging instructions and use any packaging
materials that are supplied to you for shipping.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the removal procedure, go to "Completing the parts replacement" on page 193.

Installing or removing the M.2 storage module

The M.2 storage module provides an easy way for data storage. You can install two M.2 storage drives into
the M.2 storage module. You can purchase M.2 storage modules and M.2 storage drives from Lenovo.
For a list of ThinkServer options, go to:
http://lenovoquickpick.com/usa/home/thinkserver/rack-and-tower-server
Installing the M.2 storage module
Attention: Do not open your server or attempt any repair before reading and understanding "Safety information"
on page iii and "Guidelines" on page 67.
Before you begin, print all the related instructions or ensure that you can view the PDF version on another
computer for reference.
Notes:
120
ThinkServer RD650 User Guide and Hardware Maintenance Manual