8. Remove the two riser card assemblies. See "Replacing the riser card" on page 85.
9. Remove the PCIe cards installed on the system board. See "Removing a PCIe card from the system
board" on page 100.
10. Remove the rear backplane/cage assembly. See "Removing the rear backplane/cage assembly" on
page 152.
11. Remove the AnyFabric adapter if one is installed. See "Removing the AnyFabric adapter" on page 125.
12. Lift the release pin
and release pin
2
to move the system board to the front of the server to disconnect it from the power
distribution board.
Notes:
• To show the main parts clearly, not all components are illustrated in the following figure.
• Carefully handle the system board by the release pin
Figure 192. Disengaging the system board from the power distribution board
190
ThinkServer RD650 User Guide and Hardware Maintenance Manual
2
to disengage the system board from the chassis. Then, use the lifting handle
1
2
and the lifting handle
2
1
1
.