2. Prepare your server. See "Removing or extending the server from the rack cabinet" on page 69.
3. Remove the server cover. See "Removing the server cover" on page 69.
4. locate the failing tape drive and disconnect the cable from the rear of the tape drive. Remove any
parts and disconnect any cables that might impede your access to the tape drive. See "Front view of
the server" on page 19.
5. Remove the five screws that secure the tape drive cage to the chassis. Then, remove the tape drive
cage from the front of the server.
Figure 182. Removing the tape drive cage
.
Chapter 6
Replacing hardware
181