Lenovo ThinkServer RD650 User Manual And Hardware Maintenance Manual page 184

• Do not remove the covers. Removing the covers of the laser product could result in exposure to
hazardous laser radiation. There are no serviceable parts inside the device.
• Use of controls or adjustments or performance of procedures other than those specified herein
might result in hazardous radiation exposure.
DANGER
Some laser products contain an embedded Class 3A or Class 3B laser diode. Note the following:
Laser radiation when open. Do not stare into the beam, do not view directly with optical
instruments, and avoid direct exposure to the beam.
Removing the drive partition
Attention: Do not open your server or attempt any repair before reading and understanding "Safety information"
on page iii and "Guidelines" on page 67.
Before you begin, print all the related instructions or ensure that you can view the PDF version on another
computer for reference.
To remove the drive partition, do the following:
1. Remove all external media from the drives and turn off all attached devices and the server. Then,
disconnect all power cords from electrical outlets and disconnect all cables that are connected to
the server.
2. Prepare your server. See "Removing or extending the server from the rack cabinet" on page 69.
3. Remove the server cover. See "Removing the server cover" on page 69.
4. Locate the drive partition
the drive trays 16–23.
Figure 164. Locating the drive partition
170
ThinkServer RD650 User Guide and Hardware Maintenance Manual
1 . Then remove the installed 2.5-inch drives and dummy trays (if any) from
1
1