Toro Groundsmaster 4700-D Service Manual page 89

Procedure for Cutting Deck Motor Case Drain Leak-
age Test
NOTE: Over a period of time, a deck motor can wear in-
ternally. A worn motor may bypass oil to its case drain
causing the motor to be less efficient. Eventually,
enough oil loss will cause the deck motor to stall under
heavy cutting conditions. Continued operation with a
worn, inefficient motor can generate excessive heat,
cause damage to seals and other components in the hy-
draulic system and affect quality of cut.
NOTE: One method to find a failing or malfunctioning
deck motor is to have another person observe the ma-
chine while mowing in dense turf. A bad motor will run
slower, produce fewer clippings and may cause a differ-
ent appearance on the turf.
1. Make sure hydraulic oil is at normal operating tem-
perature by operating the machine for approximately ten
(10) minutes. Make sure the hydraulic tank is full.
2. Park machine on a level surface with the cutting
decks lowered and off. Make sure engine is off and the
parking brake is engaged.
CAUTION
Prevent personal injury and/or damage to equip-
ment. Read all WARNINGS, CAUTIONS and Pre-
cautions for Hydraulic Testing at the beginning
of this section.
NOTE: The deck motors are connected in series. To
isolate a faulty motor, all motors in the circuit may have
to be tested by starting with the first motor in the circuit
(see Hydraulic Schematic).
3. Disconnect pressure return hose from the motor to
be tested (Fig. 47). Install tester with pressure gauge
and flow meter in series with the motor and the discon-
nected return hose. Make sure the flow control valve on
tester is fully open.
4. Disconnect the motor case drain hose (small diame-
ter hose) where it connects to bulkhead fitting at the
frame rail (not at the motor). Put a steel cap on the bulk-
head fitting; leave the case drain hose open.
CAUTION
Cutting deck blades will rotate when lowered
with PTO switch in ON position. Keep away from
cutting decks during test to prevent personal in-
jury from rotating blades. Do not stand in front of
the machine during test.
Groundsmaster 4500--D/4700--D
5. Sit on seat and start the engine. Move throttle to full
speed (2870 RPM). Move PTO switch to ON.
6. While watching tester pressure gauge, slowly close
flow control valve on tester until a pressure of 1200 PSI
(83 bar) is obtained.
NOTE: Use a graduated container, special tool
TOR4077, to measure case drain leakage.
7. Have a second person measure flow from the case
drain line for fifteen (15) seconds, then move the PTO
switch to OFF and stop the engine. Record test results.
TEST RESULTS: Case drain leakage less than 22.4
ounces (662 ml) of hydraulic fluid in 15 seconds (0.7
GPM / 2.7 LPM)
8. If case drain flow is more than 22.4 ounces (662 ml),
the motor is worn or damaged and should be repaired
or replaced.
9. Disconnect tester from motor and hose. Reconnect
hose to the deck motor. Remove cap from bulkhead fit-
ting and reconnect case drain hose.
10.Repeat test for additional motors if required.
#4
#6
(GM4700)
CUTTING DECK LOCATIONS
ROTATION
DIRECTION
1
1. Flow IN
2. Flow OUT
Page 4 - - 55
#1 Deck #5
#7
#2 #3
(GM4700)
Figure 46
2
3
Figure 47
3. Case drain
Hydraulic System