Toro Groundsmaster 4700-D Service Manual page 23

Removal (Fig. 5)
CAUTION
The muffler and exhaust pipe may be hot. To
avoid possible burns, allow the engine and ex-
haust system to cool before working on the muf-
fler.
1. Park machine on a level surface, lower cutting
decks, stop engine, engage parking brake and remove
key from the ignition switch.
2. Raise and support hood.
3. Remove muffler and/or muffler bracket from the en-
gine as necessary using Figure 5 as a guide.
Installation (Fig. 5)
NOTE: Make sure muffler flange and exhaust manifold
sealing surfaces are free of debris or damage that may
prevent a tight seal.
1. Install new exhaust gasket if original gasket is dam-
aged or torn.
IMPORTANT: Failure to follow the suggested muf-
fler fastener sequence may result in premature muf-
fler failure.
2. Install exhaust system components to the engine us-
ing Figure 5 as a guide. Hand tighten exhaust system
fasteners and then torque in the sequence shown in Fig.
6 as follows:
A. Torque flange nuts that secure muffler bracket to
engine from 16 to 22 ft- -lb (21 to 29 N- -m).
B. Torque flange nuts that secure muffler to muffler
bracket from 16 to 22 ft- -lb (21 to 29 N- -m).
C. Torque flange head screws that secure muffler
flange to engine from 16 to 22 ft- -lb (21 to 29 N- -m).
D. Torque flange screws that secure exhaust mount
to engine to 13 ft- -lb (17.6 N- -m).
E. Torque lock nuts used on rubber hanger cap
screws from 16 to 22 ft- -lb (21 to 29 N- -m).
F. Tighten muffler clamp nuts.
3. Tailpipe should have equal clearance between frame
and engine after installation. Also, make sure that clear-
ance exists between tailpipe and engine motor mount
bracket.
Groundsmaster 4500--D/4700--D
F
C
Page 3 - - 7
B
A
E
Figure 6
Kubota Diesel Engine
D