Toro Groundsmaster 4700-D Service Manual page 107

7. Support gear pump assembly to prevent it from fal-
ling.
8. Remove two (2) cap screws and washers securing
gear pump to piston pump. Remove gear pump, coupler
(item 9), spacer (item 17) and O--rings (item 16) from
machine.
9. If hydraulic fittings are to be removed from gear
pump, mark fitting orientation to allow correct assembly.
Remove fittings from pump and discard O--rings.
Installation (Fig. 56)
1. If fittings were removed from gear pump, lubricate
and place new O--rings onto fittings. Install fittings into
pump ports using marks made during the removal pro-
cess to properly orientate fittings. Tighten fittings (see
Hydraulic Fitting Installation in the General Information
section of this chapter).
2. Lubricate new O--rings (item 16) with clean hydraulic
oil. Position O--rings on gear pump and pump spacer
flanges.
3. Slide coupler (item 9) onto the piston pump output
shaft.
4. Position pump spacer (item 17) to gear pump. Align
gear teeth and slide gear pump input shaft into coupler.
Secure gear pump to piston pump with two (2) cap
screws and flat washers.
5. Remove caps and plugs from hydraulic hoses and
fittings. Install hoses to gear pump (see Hydraulic Hose
and Tube Installation in the General Information section
of this chapter).
6. Replace hydraulic filter and fill hydraulic reservoir
with new hydraulic oil.
7. Disconnect engine run solenoid electrical connector
to prevent engine from starting. Prime the hydraulic
pump by turning the ignition key switch to start and
cranking the engine for ten (10) seconds. Let starter cool
and then repeat cranking procedure again.
8. Connect engine run solenoid electrical connector,
start the engine and check for proper operation.
9. Properly fill hydraulic system (see Charge Hydraulic
System in this section).
10.Stop engine and check for hydraulic oil leaks. Check
hydraulic reservoir oil level.
11. Lower and secure seat.
Groundsmaster 4500--D/4700--D
RIGHT
FRONT 4
5
1. Supply hose to deck manifold P1 port
2. Supply hose to deck manifold P2 port
3. Supply hose to fan manifold P2 port
4. Supply hose to fan manifold P1 port
5. Suction hose from filter manifold
6. Suction hose from reservoir
7. Supply hose for charge circuit
Page 4 - - 73
3
6
2
7
Figure 57
Hydraulic System
1