Lincoln Electric INVERTEC SVM129-B Service Manual page 107

F-69
CAPACITOR REMOVAL AND REPLACEMENT PROCEDURE (continued)
FIGURE F.34 – REMOVING HEX HEAD NUTS OF THROUGH-BOLTS
CAPACITOR REPLACEMENT
NOTE: Capacitors must always be replaced in
matched sets (C1 and C2 as a set).
When replacing Capacitors, remove the entire
FET heat sink assembly, including the capacitors
and switch board, as a unit.
TROUBLESHOOTING & REPAIR
HEX NUT
INVERTEC STT
Disassemble and reassemble only one unit at a
time. Use the other unit as a model during
reassembly so that all parts are reinstalled prop-
erly.
14. Remove the two 3/8" hex head nuts from the
top of the through-bolts. The hex nuts are
located on top of the fan shroud. See Figure
F.34.
F-69