Lincoln Electric INVERTEC SVM129-B Service Manual page 106

F-68
CAPACITOR REMOVAL AND REPLACEMENT PROCEDURE (continued)
MOUNTING
BOLTS (5)
7. Carefully lift and tilt the Invertec STT
machine onto its right side. See Figure F.33.
8. Using the 7/16" wrench, remove the five
bolts holding the lower tray assembly to the
case bottom.
9. Carefully slide out and support the lower tray
assembly.
10. Using the needle nose pliers, remove the
strain relief holding the J22 lead harness to
the case bottom.
TROUBLESHOOTING & REPAIR
FIGURE F.33 – STT PLACED ON ITS RIGHT SIDE
INVERTEC STT
11. Using the 1/2" wrench, remove the IGBT
cable from the negative output terminal.
12. Carefully remove the lower tray assembly
clear from the machine and set aside.
13. Carefully disconnect the leads at the top of
the switch board.
F-68