Lincoln Electric INVERTEC SVM129-B Service Manual page 82

F-44
FROM PROTECTION
BOARD OVERVOLTAGE
T1 AUXILIARY
TRANSFORMER
3J31
#503A
2
4
V
A
C
2J31
7. Carefully test for 15VDC output from the
power PC board at plug J6 pin1 (lead #275)
(-) and plug J6 pin 6 (lead #302)(+). See
Figure F.15.
NOTE: If the 18VAC is present but the 15VDC is
NOT, the power PC board may be faulty.
8. Carefully test for 24VAC input from the T1
Auxiliary Transformer between plug J6 pin 4
(lead#211A) and plug J6 pin 9 (lead#212A).
See Figure F.15.
NOTE: If the 24VAC is NOT present, perform the
T1 Auxiliary Transformer Test. Also check the
associated wiring. See the Wiring Diagram. The
control PC board or thermostats may be faulty.
See Figure F.16, the Simplified Trigger Circuit
diagram.
9. Carefully test for 24VDC at the power PC
board at plug J7 pin 2 (lead #309)(+) to plug
J14 pin2 (lead #313)(-). See Figure F.15.
TROUBLESHOOTING & REPAIR
POWER BOARD TEST (continued)
FIGURE F.16 – SIMPLIFIED TRIGGER CIRCUIT
POWER BOARD
#301
11J4
7J6
#305
2J6 3J4
PWM
OUTPUTS
TO POWER
BOARD
STT II Only
#379
#224
#210
6J4
6J22
TO
5J4
POWER
BOARD
#212
12J4
INVERTEC STT
CONTROL BOARD
P
W
M
#223
9J4 8J33
6J34
#212C
NOTE: If the 24VAC is present but the 24VDC is
NOT, the power PC board may be faulty.
10. Carefully test for approximately 24VDC at
plug J7 pin 2 (lead#309)(+) to plug J7 pin 4
(lead#310)(-). If the 24VDC is NOT present,
test for approximately 1VDC at plug J14 pin1
(lead#311)(+) to plug J14 pin 2 (lead#313)(-).
See Figure F.15.
NOTE: If more than 1VDC is measured, perform
the Protection Board Test.
NOTE: If approximately 1VDC IS present and
the 24VDC is NOT present at leads #309 to
#310, the power PC board may be faulty.
11. After all tests are completed, install the front
panel assembly.
12. Install the case wraparound cover.
REMOTE
PROTECTION
BOARD
14 AMPHENOL
3.5 ohms
#413
13J36 C
3.5 ohms
#405
5J36 D
F-44