QUANTA STRATOS S210 Series S210-X2A2J Technical Manual page 238

R K A
AIL IT SSEMBLY
1. Push on the latch release buttons on the end piece mid-
points to open the rail latches.
Latch release
button
Installing the Rails
2. Align the end pieces of the rails on the vertical rack
flanges to seat the pegs in the bottom hole of the first U
and the top hole of the second U. Engage the back end of
the rail until the latch locks in place.
Note:
The rails can be used in both square-hole and round-hole racks.
3. Repeat steps 1 to 2 to position and seat the front end
piece on the vertical flange.
Note:
To remove the rails, pull on the latch release button on the end
piece midpoint and unseat each rail.
6-2
I R B
NSTALLING THE ACK RACKETS