Rear Lift Arms - Toro Reelmaster 5010- H Service Manual

Rear Lift Arms

RIGHT
FRONT
1. Housing
2. #2 lift arm
3. #3 lift arm
4. Washer (2 used per chain hoop)
5. Washer (2 used)
6. Flange head screw (2 used)
7. Shoulder stud (6 used)
8. Grease fitting
Removal (Fig. 24)
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake and remove key
from the ignition switch.
2. Remove cutting unit from rear lift arm that is to be re-
moved.
Chassis
9
10
3
17
11
8
9. Pivot shaft (2 used)
10. Washer head screw (1 used per shaft)
11. Pivot yoke (2 used)
12. Lynch pin (2 used)
13. Thrust washer (2 used per yoke)
14. RH torsion spring
15. LH torsion spring
5
7
19
8
8
2
21
13
16
Figure 24
3. Remove one retaining ring (item 3 in Fig. 25) and
thrust washer (item 4 in Fig. 25) from the cylinder pin
(item 5 in Fig. 25) that secures lift cylinder to lift arm. Pull
cylinder pin from the lift cylinder and lift arm. Locate and
retrieve second thrust washer.
4. Pivot lift cylinder rod end away from lift arm.
Page 6 - 26
14
1
15
5
12
13
20
4
18
22
16. Snapper pin (1 used per yoke)
17. Cap (1 used per yoke)
18. Chain hoop (2 used)
19. Lock nut (6 used)
20. Cap screw (2 used per chain hoop)
21. Flange nut (2 used per chain hoop)
22. Chain (2 used)
Reelmaster 5010- H
6