Headlight Switch - Toro Reelmaster 5010- H Service Manual

Headlight Switch

The headlight switch allows the headlights to be turned
on and off. This rocker switch is located on the operator
side of the control arm (Fig. 41).
NOTE: The Toro Electronic Controller (TEC) does not
monitor the operation of the headlight switch.
Testing
1. Park the machine on a level surface, engage the
parking brake, lower the cutting units and stop the en-
gine. Remove the key from the ignition switch.
2. Remove inside control arm cover to gain access to
headlight switch (see Control Arm in the Service and Re-
pairs section of Chapter 6 - Chassis).
3. Disconnect wire harness connector from the head-
light switch.
4. With the use of a multimeter (ohms setting), the
headlight switch functions may be tested to determine
whether continuity exists between the various terminals
for each switch position. The switch terminals are
marked as shown in Figure 42. The circuitry of the head-
light switch is shown in the chart below. Verify continuity
between switch terminals.
SWITCH NORMAL
POSITION CIRCUITS
ON
OFF
5. Replace headlight switch if testing determines that it
is faulty.
6. When headlight switch testing is complete, connect
wire harness connector to the switch. Install control arm
cover to machine (see Control Arm in the Service and
Repairs section of Chapter 6 - Chassis).
Reelmaster 5010- H
OTHER
CIRCUITS
2 + 3 5 + 6
2 + 1 5 + 4
Page 5 - 51
2
Figure 41
1. Console arm
BACK OF SWITCH
Figure 42
NOTE: Headlight switch terminals 1, 4, 5 and 6 are not
used on Reelmaster 5010- H machines.
1
2. Headlight switch
Electrical System