Toro Reelmaster 5010- H Service Manual page 248

IMPORTANT: Before wheel hub is installed, thor-
oughly clean tapers of wheel hub and wheel motor
shaft. Make sure that tapers are free of grease, oil
and dirt. DO NOT use antiseize lubricant when
installing wheel hub.
6. Mount square key in the wheel motor shaft, then
install the wheel hub onto the wheel motor shaft.
7. Secure wheel hub onto the wheel motor shaft with
lock nut (item 12).
8. Install brake drum.
9. Position brake cable end to brake actuator lever (Fig.
8). Secure brake cable clevis to brake actuator lever with
clevis pin and extension spring.
10.Install front wheel assembly (see Wheels in this sec-
tion).
Chassis
11. Check and adjust brakes.
12.Lower machine to ground.
13.Torque wheel lug nuts evenly in a crossing pattern
from 70 to 90 ft- lb (95 to 122 N- m). Torque lock nut
(item 12) that secures wheel hub from 315 to 385 ft- lb
(428 to 522 N- m).
After servicing the brakes, always check the
brakes in a wide open, level area that is free of
other persons and obstructions.
Page 6 - 10
CAUTION
Reelmaster 5010- H