Troubleshooting; Groomer Reel Mechanical Problems - Toro Reelmaster 5010- H Service Manual

Troubleshooting

Groomer Reel Mechanical Problems

Problem
No rotation of the groomer reel.
The turf is damaged or has uneven
grooming.
Reelmaster 5010- H
Possible Causes
The groomer drive belt needs to be
adjusted.
Failed groomer idler bearing(s) in
groomer side plate(s).
Broken or damaged idler spring.
The groomer drive belt is worn, bro-
ken or damaged.
Grooming depth is too deep.
Groomer drive shaft is loose in cut-
ting reel.
Groomer drive pulley square key is
damaged or missing.
Flange head screw that secures
groomer drive pulley is loose or
damaged.
The groomer reel blades are bent,
damaged or missing.
The groomer reel shaft is bent or
damaged.
Grooming depth is not equal on
both ends of groomer reel.
Page 8 - 5
Correction
Adjust groomer drive belt.
Replace faulty bearing(s).
Replace spring.
If the drive belt slips, it probably is
out of adjustment or worn.
Repair or replace drive belt if nec-
essary. A broken or worn belt could
be the result of improper belt rout-
ing or seized bearings in groomer
assembly.
Change grooming depth.
Correctly tighten groomer drive
shaft. Replace drive shaft if threads
are faulty.
Replace missing or damaged
square key.
Correctly tighten groomer drive pul-
ley with existing flange head screw.
Replace screw if threads are faulty.
Repair or replace blades if neces-
sary.
Replace groomer reel shaft.
Adjust depth if necessary. Also,
check and adjust cutting unit set up
(level bedknife to reel, level rear
roller to reel, set height- of- cut,
etc.).
Groomer