Operator Seat - Toro Reelmaster 5010- H Service Manual

Operator Seat

22
RIGHT
FRONT
1. Operator seat
2. Seat base
3. Seat adjuster w/latch
4. Flat washer (4 used)
5. Seat switch harness
6. Seat switch
7. Washer head screw (2 used)
8. Armrest bracket
9. Spacer
10. Armrest
IMPORTANT: The operator seat, seat base and con-
trol arm assembly are attached to the machine with
the same fasteners. Make sure to support the seat
base and control arm to prevent them from shifting
when removing the seat. Damage to control arm
electrical components and control arm wiring har-
ness can occur if the seat base and control arm are
not properly supported during seat removal.
Chassis
27
28
23
5
6
7
20
21
16
13
24
25
19
Figure 15
11. Cap screw
12. Flange nut
13. Flat washer (4 used)
14. Flange head screw (3 used)
15. Socket head screw (4 used)
16. Seat adjuster
17. Flat washer
18. Seat bracket (2 used)
19. Cap screw (4 used)
20. Housing cap
Page 6 - 20
1
3
21. R- clamp (2 used)
22. Manual housing
23. Seat belt buckle
24. Flange nut (4 used)
25. Seat suspension
26. Flange head screw (4 used)
27. Cap screw (2 used)
28. Lock washer (2 used)
29. Seat belt
12
10
11
14
9
8
17 29
28
27
2
4
15
13
24
26
18
Reelmaster 5010- H