About Screen - Toro Reelmaster 5010- H Service Manual

Height of Cut (HOC) identifies the setting for cutting
unit height of cut. This information is used by machine
controllers to determine cutting unit reel speed.
F Reel RPM displays the front reel speed that has been
determined by the machine controllers based on en-
tered information for blade count, mow speed and HOC.
Front reel speed can also be manually adjusted.
R Reel RPM displays the rear reel speed that has been
determined by the machine controllers based on en-
tered information for blade count, mow speed and HOC.
Rear reel speed can also be manually adjusted.

About Screen

The about screen (Fig. 24) identifies the machine model
number, machine serial number and software revisions
for the TEC controller. If the machine PIN has been en-
tered to allow protected menu items to be visible, the
about screen will also identify software revisions for the
cutting unit and motor/generator controller and list the
CAN- bus status.
To return to the main menu screen from the about
screen, press the back button (left button).
Reelmaster 5010- H
Economy Mode displays whether the machine has the
economy mode feature ON or OFF. When in economy
mode with the mow/transport lever in the MOW position,
the engine speed is lowered to reduce noise and fuel
consumption. When in economy mode with the mow/
transport lever in the TRANSPORT position, engine
speed is not lowered.
To return to the main menu screen from the settings
screen, press the back button (left button).
1
2
5
3
5
1. About menu
2. About items
3. Move to menu items
Page 5 - 17
About
Model: 03674
SN: 315000153
S/W Rev: 122- 0059B
4
3
Figure 24
4. Choose menu item
5. Back button
Electrical System