Jacking Instructions; Jacking Instructions - Toro Reelmaster 5010- H Service Manual

Jacking Instructions

CAUTION
When changing tires, attachments or perform-
ing other service, use correct hoists, jacks and
jack stands. Make sure machine is parked on a
solid, level surface such as a concrete floor.
Prior to raising machine, remove any attach-
ments that may interfere with the safe and prop-
er raising of the machine. Always chock or
block wheels. Use jack stands or other ap-
propriate load holding devices to support the
raised machine. If the machine is not properly
supported, the machine may move or fall,
which may result in personal injury.
Front End Jacking (Fig. 1)
1. Apply parking brake and chock both rear tires to pre-
vent the machine from moving.
2. Position jack securely below the rectangular pad un-
der the frame axle tube, just to the inside of the front
wheel.
3. Jack front of machine off the ground.
4. Position jack stands under the frame as close to the
raised wheel as possible to support the machine.
Rear End Jacking
1. Apply parking brake and chock both front tires to pre-
vent the machine from moving.
2. Place jack securely at the center of the rear axle un-
der the axle pivot bracket. Jack rear of machine off the
ground.
3. To support the raised machine, position jack stands
under the frame rail next to the axle support bracket.
Reelmaster 5010- H
1. Front wheel
Page 1 - 5
2
1
Figure 1
2. Front jacking point
Safety