3. Connect the safety wire (attached to the camera) to the surface mount as shown.
Then, arrange the cables.
For more information about the wiring, refer to "Camera Wiring Interface Board". (Page 18)
4. Arrange the cables inside the surface mount so that they should not be entangled or stuck
in, and align the guide rib of the camera with that of the surface mount. Use the L-shaped
wrench to tighten the screws (x4) so that the camera is secured to the mount.
To ensure waterproofness, take caution lest that the outer gasket should get loose or be
stuck in.
Safety-wire
Surface Mount
Main-frame
Gasket
Guide Rib of
Surface Mount
Guide-Rib of
Main-frame
Screw
English _37