Samsung SNP-3120 User Manual page 103

WDR Setup
You can set to display a sharp image of the objects in a scene where both bright and dark
areas exist.
1. Select <Backlight>.
2. Set <Mode> to <WDR>.
3. Select each item and set it properly.
• WDR Limit : Set the WDR sensitivity.
• WDR Level : Specify the WDR
sensitivity level.

M
If WDR mode is active, the shutter mode
cannot be changed. Data transfer via the
network is available at up to 15 fps.

If the WDR mode is active, a moving object can cause an afterimage on the screen.
Ex)
<WDR OFF>

J
If you select WDR, you may encounter the following problems. So set it to Not Used.
- Unnatural change of colors that cause an unnatural image on the screen
- Noise on the bright area of the image

As the performance of the WDR function may differ depending on the bright-area size of the
image, it is recommended to optimize the installation angle for the best performance.

At night operation, this function will be activated only if the incoming highlight exceeds a certain
area in a low contrast environment.

Increasing the maximum value may cause an unnatural portion of the image.
<WDR ON>
English _103