Show Raid Physical_Drive_Count - Fujitsu PRIMEQUEST 2000 Series Tool Reference

MMB CLI (Command Line Interface) Operations
2.3 Commands for Display
The specified parameter is invalid. %s
The specified controller is not found.
Port and cascade number is required in the parameter since more than 2 enclosures are connected.
Internal error [%d:%d].
Unable to execute the command because the system is under maintenance.
Unable to execute the command because the Partition#%d is under maintenance.

2.3.49 show raid physical_drive_count

Displays disk counts attached to the specified RAID adapter.

Privilege: Aｌｌ
(1) Input format
show raid physical_drive_count [SB | DU | IOU | PCI_BOX] <UNIT#>-<PCISLOT#>
{encl=<Port#>-<Cascade#>}
(2) Option
encl: This option specifies port, cascade and slot number for the target disk enclosure. (ex. encl=0-0).
(3) Usage example

Example: When you display disk count attached to the RAID adapter on SB#0.
# show raid physical_drive_count SB 0-0
3

Example: When you display disk count in the disk enclosure port#0-cascade#0 attached to the RAID
adapter on IOU#0-PCI slot#1.
# show raid physical_drive_count IOU 0-1 encl 0-0
24
(4) Message
The following table lists the messages which are displayed in this CLI.
For details of the messages, see the PRIMEQUEST 2000 Series Message Reference (CA92344-0540)..
Too much arguments argc=%d.
Too few arguments argc=%d.
The specified parameter is invalid. %s
The specified controller is not found.
Internal error [%d:%d].
The operation is failed. %s
Unable to execute the command because the %s is under maintenance.
477
CA92344-0539-04