Modify Raid Logical_Drive - Fujitsu PRIMEQUEST 2000 Series Tool Reference

MMB CLI (Command Line Interface) Operations
2.2 Setting Commands

2.2.55 modify raid logical_drive

Modifies a logical drive to the specified RAID controller.

Privilege: Administrator, Operator, Partition Operator (Only managed partition)
(1) Input format
modify raid logical_drive [SB | DU | IOU | PCI_BOX] <UNIT#>-<PCISLOT#>
target=<TargetID> {[disk=<DISKSLOT#>{,<DISKSLOT#>...} | disk=<PORT#>-<CASCADE#>-
<DISKSLOT#>{,<PORT#>-<CASCADE#>-<DISKSLOT#>...}]} {level=<RAIDlevel>} {force}
(2) Option
target: This option specifies targetID of the target logical drive which you want to modify. (ex. target=0)
disk: This option specifies disk slot numbers for the internal disks (e.g. disk=0,1,2,3) or port number and
cascade numbers and disk slot numbers for the external disks on disk enclosures (e.g. disk=0-0-0,0-0-
1,1-0-0,1-0-1).
level: This option specifies RAID level from 0, 1, 5, 6 1E, 10, 50 or 60. (ex. level=5).
force: The command is executed without interactive operation with the user.
(3) Usage example

Example:When you modify RAID level of a logical drive to RAID 6 as RAID level migration (RLM) with
additional disk attached to slot#3.
# modify raid logical_drive SB 0-0 target=0 disk=3 level=6
(4) Message
The following table lists the messages which are displayed in this CLI.
For details of the messages, see the PRIMEQUEST 2000 Series Message Reference (CA92344-0540).
The command is executed successfully.
The operation is canceled
Too much arguments argc=%d.
Too few arguments argc=%d.
The specified parameter is invalid. %s
The specified controller is not found.
Internal error [%d:%d].
The operation is failed. %s
Unable to execute the command because the %s is under maintenance.
Unable to process raid operation because you have not authority to access to the system assigned to the raid
controller.
Unable to process raid operation because you have not authority to access to the Partition#%d assigned to the
raid controller.
414
CA92344-0539-04