Fujitsu PRIMEQUEST 2000 Series Tool Reference page 367

MMB CLI (Command Line Interface) Operations
2.2 Setting Commands
(4) Message
The following table lists the messages which are displayed in this CLI.
For details of the messages, see the PRIMEQUEST 2000 Series Message Reference (CA92344-0540).
The specified parameter is invalid.
The specified partition number is invalid.
Unable to power on the partition#%d due to CPU mismatch between SBs.
Unable to power on the partition#%d due to DIMM does not satisfy requirements of Mode.
Unable to power on due to mismatch between supply voltage and input voltage.
Unable to power on the partition#%d due to abnormal DIMM composition.
Unable to power on the partition#%d due to abnormal SB composition.
Unable to power on the partition#%d.
Command Failed. Code=0x%04X, 0x%02X
Unable to execute this command on a standby MMB
Unable to power on the partition#%d due to no Home SB.
Unable to execute this command because the system is under maintenance.
Unable to execute this command because the Partition#x is under maintenance.
The Power On failed, because of switching the Home SB.
Please execute it after a while again.
Unable to power on the Partition#n because you have not authority to operate this partition.
Unable to power on the partition(s) because the partition which does not have authority to you is included in
the specified parameter.
Unable to execute this command because Extended Partitioning mode of the Partition#x is Enabled.
Unable to execute power control because the firmware is updating.
Unable to execute command because the power control operating.
366
CA92344-0539-04