Printer Settings - Kodak 7000 User Manual

Printer Settings

Display
Ready
Energysave Mode
Test Print Mode
Remain = XXX/YYY
Printed = XXXXXX
Donor = XXX[%]
Main Firm = XX . YY
DSP Firm = XX . YY
USB Firm = XX . YY
TABLE Firm = XX . YY XX . YY represents the print parameter table version number.
Use the operator panel buttons to review and change printer settings.
Printer settings
are displayed here
Press Menu to enter Setup Mode.
1.
Press Menu repeatedly to scroll through the printer settings.
2.
Press +/- to scroll through selections.
3.
Press Enter to initiate an action or accept a change.
4.
Press Clear to exit Setup Mode.
5.
Description
The printer is on and ready to make prints.
When selected, press Enter, then + or - to enable or disable Energy
Save mode (the default is off). When enabled, to conserve power, the
printer does not maintain printing temperature when idle. The printer
takes additional time to warm-up before initiating printing.
When selected, press Enter to make a test print. See
Print" on page 1-11.
XXX represents how many remaining prints you can make with the
current paper roll. YYY represents the total number of prints on a
paper roll. The counter is reset each time you press Paper Rewind.
XXXXXX represents the total number of prints made since the printer
was manufactured. This counter cannot be reset.
XXX[%] represents the percentage of the installed ribbon that is
available for making prints.
XX . YY represents the printer control firmware version number.
XX . YY represents the image processing firmware version number.
XX . YY represents the USB firmware version number.
Operating the Printer
3
1,2
4 5
"Making a Test
2-3