Printer Settings
Printer Serial
Number
Display - Level 1
Ready 6x8
Ready 5x7
REMAIN XXX/XXX
PRINTED XXX
MAIN APP
TABLE
FPGA
MAIN BOOT
October 2020
Use the operator panel buttons to review and change printer
settings.
1. Click MENU to enter User Mode and to scroll through the
Main Menu options.
2. Click UP or DOWN to adjust settings up or down (where
applicable). If an adjustment is made, you must click ENTER
to save that adjustment.
3. Click ENTER to initiate an action or accept a change.
4. Click MENU to exit User Mode.
5. Click BACK to return to the top line of whatever menu you are
in.
6. Click FEED to advance the paper and cut a 4.2 x 6 in. sheet.
7. If the printer is in a "Ready" state, and you click BACK, the
paper rewinds into the printer.
Printer settings are displayed here
Display - Level 2
----
----
----
----
----
----
----
2
Description
The printer is on and ready to make prints. 6x8 or
5x7 represents the size of ribbon that is loaded.
Total number of prints printed and remaining
number of prints.
Total number of prints printed.
Main firmware version number.
Print parameter table version number.
FPGA version number.
Boot firmware version number.
Operating the Printer
1, 4
6
5
3
4-3