Label
Plastic wrapper
Insert your fingers into the holes in the plastic wrapper on the end of the
2.
ribbon. Remove the plastic wrapper from the ribbon.
Do not remove the label from the ribbon at this time.
IMPORTANT:
Push the bar code end of the supply spool onto the front spool holder on
3.
the right.
Insert the left side of the supply spool onto the front spool holder on the
4.
left. Align the notches on the supply spool with the lugs on the spool
holder.
Adjust the supply spool until the spool locks into the spool holder.
5.
Remove the label.
6.
Setting Up the Printer
1-7